Sanyo VMC-8618 - Manual (Page 12)

ADJUST THE OSD MENU ITEM
Displaying characters such as for setting
location on the monitor screen (Refer to
“CHARACTERS TABLE”.)
Note: If there is no signal being input from the input
terminals selected (A, B or Y/C) at the rear of
the monitor, the title cannot be set for those
terminals.
1 Select “9. TITLE ON” and then press the
ENTER button.
2 To display “ABCD” on the CH B monitor as an
example:
A maximum of eight characters can be displayed
on the screen.
Note: The setting screen will disappear after
approximately 13 seconds of no activity.
1. Use the cursor ( l ) button to select “CH B”.
2. Press the ENTER button, and then use the cursor l
( j ) button to select “A”.
3. Press the ENTER button, and then use the cursor l
( j ) button to select “B”.
4. Press the ENTER button, and then use the cursor l
( j ) button to select “C”.
5. Press the ENTER button, and then use the cursor l
( j ) button to select “D”.
6. Press the OSD button.
The cursor will move to the next monitor display.
The settings for the CH A and CH Y/C monitors can
be carried out by the same procedure as described
above.
3 Use the cursor l ( j ) button to select “TITLE
ON”, and then press the ENTER button.
The text that has been set for that monitor screen
will then be displayed.
OSD
CHARACTERS TABLE
L8MV5/US, L8MW5/US (VMC-8618, 8613 GB) 2001. 2. 23
10