Sundance Spas 880 - Manual (Page 5)

880 Waterfall Control Valve (2005+ Optima & Cameo)
Turn valve counterclockwise to increase waterfall output.
Turn clockwise to decrease or turn off waterfall output.
Note: it takes 4 full revolutions to change the waterfall
from a full off to a full on flow rate.
880 Filter Cartridge Replacement (2005+ Optima &
Cameo)
A programmable “Change Filter” reminder flashes on the
control panel display after a specified number days to remind
you to inspect and/or replace the MicroClean II filter cartridge.
This reminder must be reset at each filter inspection/replace-
ment interval. Refer to page 2 of this addendum sheet for
additional information and programming details.
Your Sundance hot tub is equipped a high-efficiency MicroClean II filter car-
tridge under the filter lid. Debris is filtered by the circulation pump drawing
water through this cartridge 24-hours a day, 7 days a week (unless pro-
grammed otherwise.) To ensure optimum performance, replace this car-
tridge every 6 months or as needed. This filter cannot be cleaned and
reused and MUST be thrown out after use.
All spas also include filters on their footwell suction covers that
prevent debris from entering either jets pump system and related
massage selector valve when running. The suction filters must
remain in place to protect these components from debris entrap-
ment/damage and should be cleaned every 2 months, or when weak jets
pump performance is observed.
ALWAYS TURN POWER TO THE HOT TUB OFF BEFORE REPLACING
THE MICROCLEAN II FILTER CARTRIDGE! To accomplish this, refer to
the following filter replacement procedure:
B
A
C
Replace (throw-away) the MicroClean filter cartridge
every 6 months, or as needed! DO NOT reuse this
cartridge for any reason! Loosen filter nut (A) to provide clearance,
then remove used MicroClean II filter
cartridge (steps B-C).
TURN POWER TO HOT TUB OFF!
Filter
Nut
Replace MicroClean II
cartridge every 6
months, DO NOT
Reuse for any reason!
B
C
A
CHANGE
FILTER
Full
On
Full
OFF
4x
4x
Page 5