0 water quality maintenance, 1 ph control, 2 sanitizing – Sundance Spas 880 User Manual
Page 43
12.0 Water Quality Maintenance
Maintaining the quality of the water within specified limits will serve to
enhance your enjoyment and prolong the life of the hot tub's equipment. It
is a fairly simple task, but it requires regular attention because the water
chemistry involved is a balance of several factors. There is no simple formu-
la, and there is no avoiding it. A careless attitude in regard to water mainte-
nance will result in poor and potentially unhealthful conditions for soaking
and even damage to your hot tub investment. For specific guidance on
maintaining water quality, consult your Authorized Sundance Dealer who
can recommend appropriate chemical products for sanitizing and maintain-
ing your hot tub.
CAUTION: Never store hot tub chemicals inside the hot tub's equipment bay.
12.1 pH Control
pH is a measure of relative acidity or alkalinity of water and is measured on
a scale of 0 to 14. The midpoint of 7 is said to be neutral, above which is
alkaline and below which is acidic. In hot tub water, IT IS VERY IMPORTANT
TO MAINTAIN A SLIGHTLY ALKALINE CONDITION OF 7.2 to 7.8. Problems
become proportionately severe the further outside of this range the water
gets. A low pH will be corrosive to metals in the hot tub equipment. A high
pH will cause minerals to deposit on the interior surface (scaling). In
addition, the ability of the sanitation agents to keep the hot tub clean is
severely affected as the pH moves beyond the ideal range. That is why
almost all hot tub water test kits contain a measure for pH as well as
sanitizer.
12.2 Sanitizing
To destroy bacteria and organic compounds in the hot tub water, a sanitizer
must be used regularly. Your Sundance hot tub is equipped with the
Brominator™, a special compartment built into the floating skimmer gate to
hold bromine tablets. By regulating the number of bromine tablets in the
Brominator™ and the length of the filtration cycles, you can control the
amount of bromine which is actively working in your hot tub water. A
bromine residual of 2 to 3 ppm is generally considered desirable. A two-
part bromine system or granular chlorine (Dichlor) are also acceptable sani-
tizers.
IMPORTANT: Do not use chlorine tablets (Trichlor) in your hot tub. This
chemical can have an extremely corrosive effect on certain materials in
the hot tub. Damage caused by use of this chemical, or improper use of
any chemicals, is not covered under the hot tub's warranty.
Page 34
ENGLISH