Sundance Spas 880 - Manual (Page 42)

Page 33
the equipment compartment. Replace the drain plugs.
7. Loosen hose clamp at bottom of heater (Figure-A, Page 6) and pull
hose off of heater fitting (twist the hose back and forth while pulling
downward). Tip hose down and allow to drain.
8. Re-install cabinet side panels and cover hot tub so that no casual
moisture can enter into it. Consult your Authorized Sundance Dealer if
you have any questions regarding winter use or winterizing.
11.9 Restarting Your Hot Tub in Cold Weather
If you want to start up your hot tub after it has sat empty for a time in
freezing temperatures, be aware that the water remaining in certain sections
of the piping may still be frozen. This situation will block water flow prevent-
ing the hot tub from operating properly and possibly damaging the equip-
ment. We recommend you consult your dealer for guidance before attempt-
ing to re-start your hot tub under these conditions.
11.10 Handrail Maintenance
The handrails in your Sundance spa are manufactured from a high quality
316 stainless steel alloy. Many people are familiar with the term “stainless
steel” and are surprised to learn that it does indeed rust and corrode in the
presence of chloride salts, free chlorine, or sulfide gasses. The bad news is
the environments that produce these elements are ocean spray, salted high-
ways, chemical treatments added to swimming pools and spas, and ground
water in numerous coastal areas. The good news is with proper care, your
spa’s handrails can maintain their original finish.
If your stainless handrails shows signs of rusting you should:
•
Wash with fresh water (a good detergent won’t hurt).
• Clean with a good car chrome polish.
• Wax with an automotive or fiberglass wax.
You should never:
•
Clean with chlorinated cleaners or scouring powders.
• Use sand paper, “Scotch Brite”, Brillo pads, or similar abrasive products.
• Clean with muratic or hydrochloric acids. Vinegar is ok, but it won’t do
much to remove rust.
ENGLISH