Sanyo 710-00792-1 - Manual (Page 7)

6
ASSEMBLE STORAGE SPACES
Replace the Back Cover to the Top Cabinet. Turn
the Back Cover over, and fix the cover in the
reverse to the initial position.
Replace Back Cover 1
Back Cover
Screws (14 pcs)
IInsert the Shelves' Pins into appropreate position
of the walls of Storage Spaces. Install the
Compartment Shelves in Storage Spaces.
1. Remove the Hinge Covers by removing the 2
screws of each Hinge.
2. Hold the Glass Doors between the Glass Hinges
and the Hinge Covers. Install the Glass Doors so
that the side with the Holder Magnet is matched
to the magnet inside of the Storage Spaces. Do
not install the Glass Doors in the reverse.
Tighten the screws and fix the Glass Doors.
1. When adjusting the position of the Glass Doors,
loose the Screws(A) and move the Glass Doors
with the Hinges to the arrow direction until the
surface of the door matches to the surface of the
Cabinet Front.
2. When adjusting the tilt of the Glass Doors, adjust
the Screws(B) (lower and upper) and move the
Glass Doors.
Install Glass Doors
Adjustments of Doors
Install Compartment Shelves
2
3
4
Holder Magnet
Screws
(2pcs x 4)
Glass Door
Screw(A)
Screw(B)
Shelves' Pins
(4 pcs X 4)
Compartment
Shelves (4 pcs)
Holder Cover