Woodstock W1736 - Manual (Page 9)

SET
UP
-7-
W1736 Overarm Router (Mfg. 8/10+)
This machine has been carefully packaged for safe trans-
portation. If you notice the machine has been damaged
during shipping, please contact your authorized Shop Fox
dealer immediately.
READ and understand this entire instruc-
tion manual before using this machine.
Serious personal injury may occur if
safety and operational information is not
understood and followed. DO NOT risk
your safety by not reading!
Unpacking
SET UP
The following items are needed, but not included, to
setup your machine:
• Air Compressor .............................................1
• Air Hose with 3/8" Female Quick Connect Fitting ...1
• Hex Wrench 6mm ..........................................1
• Hex Wrench 8mm ..........................................1
• Phillips Screwdriver .......................................1
• Open-End Wrench 12mm .................................1
• Open-End Wrench 17mm .................................1
• Router w/Removable Base ...............................1
• Mounting Hardware Specific to Application .....Varies
Items Needed for Set Up
Cleaning Parts
The table and other unpainted parts of your overarm
router are coated with a waxy grease that protects them
from corrosion during shipment.
Clean this grease off with a solvent cleaner or citrus-
based degreaser. DO NOT use chlorine-based solvents such
as brake parts cleaner or acetone—if you happen to splash
some onto a painted surface, you will ruin the finish.
MAKE your shop “child
safe.” Ensure that your
workplace is inaccessible
to youngsters by closing
and locking all entrances
when you are away. NEVER
allow untrained visitors in
your shop when assem-
bling, adjusting or operat-
ing equipment.