Speco Technologies LCD Monitor M19LCBVH3 - Manual (Page 7)

GEOETRY
H-POSITION: Moves the image on screen
either left (
－) or right (＋).
V-POSITION: Moves the image on screen
either up (
＋) or down (－).
CLOCK: If the clock is not fine-tuned, you
may observe periodic vertical bars of
video noise on your image. These bars of
noise are usually adjusted out when an
Auto Configuration is performed. If the
bars of noise are still present, this setting
can be adjusted manually.
PHASE: Adjusts the signal phase to
improve sharpness when the image is
fuzzy.
AUTO ADJUST: Performs automatic
configuration of the Phase, Clock, vertical,
and horizontal position settings.
AUDIO
BASS: Adjustment range:0-100
TREBLE: Adjustment range:0-100
BALANCE: Adjusts how much audio is
sent to the left and right (-50 to +50).
The intermediate value is 0. When
indication value of balance increases
toward +50, the volume of the right and
left speaker increase and decrease. When
the indication value of balance decreases
toward -50 the volume of the right and left
speaker increase and decrease.
SOUND MODE: Provides special
processing through your speakers
(depending on the setting you chose as
your Sound Type). The available audio
modes are: Standard, User, Movie, Music)
AVC: (Automatic Volume Control)
ON & OFF
2. AV Input Mode
PICTURE
CONTRAST: Adjusts the difference
between the light and dark areas of the
picture.
BRIGHTNESS: Adjusts the brightness of
the picture.
HUE: -50 to +50 (only available on AV
PAL)
SATURATION: 0-100
SHARPNESS: 0-100
COLOR TEMP:
Press the “+” button to
change the color intensity of the
temperature selected (Normal, Warm,
Cool, S-RGB, User)
SCALE: Full, Normal, or Center
PICTURE MODE: User, Standard, Soft, or
Vivid
OSD
LANGUAGE: Lets you select your
preferred language for the menus:
(English, Chinese, German, French,
Spanish, Italian, Portuguese, or Russian)
OSD H-POSITION: Adjust the OSD image
horizontally by pressing the + or
– buttons.
OSD V-POSITION: Adjust the OSD image
vertically by pressing the + or
– buttons.
DURATION: 5-60
HALFTONE: 0-100
BACKLIGHT: HIGH MID LOW
MEM-RECALL: Pressing the + key will be
reset all settings to the factory default
settings.
12 13