Samsung SCX-5115 - Manual (Page 133)

I NSTALLING A N ETWORK O PTION A.10
Configuring Netware
On IPX/SPX protocol networks (for example, Novell NetWare),
the format of network communication frames must be specified
on the printer. In most cases, you can keep the default setting
on “AUTO.” However, you can manually set the frame type
format if required.
• AUTO (default): Automatically senses and limits the frame
type to the first one detected.
• IEEE802.3: Limits the frame type to IPX over IEEE 802.3
frames. All others are discarded.
• ETHERNET II: Limits the frame type to IPX over Ethernet
Frames. All others are discarded.
• IEEE802.2: Limits the frame type to IPX over IEEE 802.2 with
IEEE 802.3 frames. All others are discarded.
• SNAP: Limits the frame type to IPX over SNAP with IEEE
802.3 frames. All others are discarded.
Take the following steps to change the frame type format:
1 Press Menu/Exit and then System Setup on the one-
touch dial keypad. SCX-5115 users should press Menu and
then Enter.
2 Press or to display “NETWORK SETUP” on the top line.
3 Press or to display “CONFIG NETWORK” on the
bottom line.
4 Press Mode/Enter (Enter for SCX-5115) to access the
menu.
5 Press or to display “NETWARE” on the bottom line.
6 Press Mode/Enter (Enter for SCX-5115).
7 Press or to select the frame type you want to set and
press Mode/Enter (Enter for SCX-5115).
If you don’t want to enable the Netware protocol,
select “OFF”.
8 To return to Standby mode, press Stop/Clear.