Sharp LL-171G - Manual (Page 21)

22
MODE SELECT-1 Menu
Note:
- Depending on the resolution of the input signal,
even if menu options can be selected, the
display may not change.
OSD H-POSITION (OSD horizontal position)
The position of the OSD Menu can be moved to
the left and right. ( buttons)
OSD V-POSITION (OSD vertical position)
The position of the OSD Menu can be moved up
and down. ( buttons)
SCALING (Level of scaling)
The sharpness of the image can be adjusted.
( buttons)
Note:
- When the display mode is set to less than
1280 x 1024 pixels, the display is enlarged to
cover the whole screen (i.e. the side ratio of the
display may change).
400LINES (degree of resolution)
(When using an analog signal)
You can specify the horizontal resolution of a 400-
line screen when using US text, etc. ( buttons)
640: 640 x 400 dot mode
720: 720 x 400 dot mode (US text etc.)
Note:
- As the resolution input for other than 400 lines is
done automatically, there is no need to set it.
LANGUAGE
You can choose the language used in OSD Menu.
1. Press the button.
The Language Selection Menu will be displayed
on the screen.
2. Use the / MODE button to choose a language.
3. Press the MENU button.
Adjusting the screen display
MODE SELECT-2 Menu
INFORMATION
A model name (MODEL), a serial no. (S/N), and
usage time (USAGE TIME) of the monitor can be
checked.
1. After selecting [INFORMATION], press the
button.
The product information will display.
2. Press the MENU button.
OFF TIMER
Power is automatically shut off when the set time
elapses.
1. After selecting [OFF TIMER], press the button.
2. Set [ON]/[OFF] by pressing the buttons.
If selecting [ON], press the / MODE button and
set the shut-off time by pressing the buttons.
(Between 1 and 23 hours may be set, by the
hour.)
3. Press the MENU button.
- When [ON] is selected, the remaining time is
displayed in the upper right of the screen during
the last 5 minutes before the shut-off. (The
remaining time is displayed for approx. 5
seconds, on each minute.)
- If the power button is pressed after the first
display of the remaining time but before the
power shuts off, the OFF TIMER will be set to
one hour.
To subsequently turn the power off, press the
power button again. (When next turning on
power, power is again automatically shut off
when the set time elapses.)
- If the monitor is turned on when the [OFF TIMER]
is set to [ON], the set time appears on the display
for several seconds. (If there is no input signal,
[NO SIGNAL] is displayed.)
INPUT-2 [LL-171G]
Set [1LINE] when connecting digital or analog
signal cables to a DVI-I input terminal (INPUT-2) on
the display.
Set [2LINES] when connecting a 2-input cable.
( buttons)
- If the connections and settings are not correctly
set, the screen will not be correctly displayed.
171AG_gb.P65 12/4/2003, 1:14 PM 22