Sharp UX-465L - Manual (Page 33)

Setting Up and Using OpenLCR
31
2. S
e
tting Up
O
penLCR
Don’t unplug the
fax, or the rate
data will be lost!
Caution!
If you unplug the fax machine or an
interruption occurs in your power
supply, the rate data will be erased. If
this happens, the highlighted “C” in
the display will blink to alert you.
The fax machine will automatically
call OpenLCR within the next 24
hours to receive new rate data;
however, if you want to use OpenLCR
service before that time, you should
download the rate table manually as
explained on page 29.
♦
We recommend that you do not
unplug the fax machine on a
regular basis (for example at night
or on the weekends), as this will
result in a large number of calls to
OpenLCR and a higher phone bill
depending on where you live.
Each time you make a long distance
phone or fax call, the fax machine will
automatically route the call through
the least expensive carrier based on
the downloaded rate information. The following table shows marks
related to OpenLCR that may appear
in the display.
Mark Meaning
OpenLCR has been
activated and is ready for
use.
(Blinking)
OpenLCR cannot be used
because the rate data has
been erased. Your fax will
automatically call OpenLCR
within the next 24 hours to
receive new data, or you
can download the data
manually if you need to use
OpenLCR immediately.
See
Downloading
(receiving) the rate data
manually on page 29.
The rate data in the fax is
no longer correct and the
fax cannot connect to
OpenLCR to obtain new
data. See
What to do if “E”
appears in the display on
page 33.
OpenLCR has been
temporarily turned off. See
Temporarily turning off
OpenLCR below.
Rate data was not yet
available when your fax
called OpenLCR. Your fax
will automatically call
OpenLCR again when the
rate data is available. Until
that time, long distance
calls will be routed through
your primary carrier.