Sharp TINSZ2601RCZZ - Manual (Page 67)

65
If an error occurs while data is transferred from your cash register to the inserted SD memory card and vice
versa, it will be indicated by a corresponding error code shown on the operator display. Press the
l key to
clear the error, then take the corresponding action.
SD error code table
In Case of SD Error 2
Recommended SD memory cards
We recommend you to use the SD memory cards made by SanDisk Corporation. If you want to know the SD
memory card in detail, please visit the Sharp web site: http://www.sharpusa.com.
• The data stored in an SD memory card could be lost or distorted due to accidents or other issues.
Sharp is not responsible for any damage incurred by lost data.
• Only the FAT(FAT16) formatted SD memory card is available on your cash register.
If you have a SD memory card formatted with FAT32, please format it to FAT16 using Windows
PC and then reformat it on your cash register before you use.
• 128-Mbyte to 2-Gbyte SD memory cards are available and the relationship between the memory
card capacity and the maximum holding period of sales data which can be saved in an SD
memory card is as follows:
Memory card capacity Sales data holding period *
128MB 3 Months
256MB 6 Months
512MB 1 Year
2GB/1GB 1 Year
*: This period refers to the time period during which sales data can be stored in an SD memory card
when additionally written onto it once a day.
Display
Error status and action
(Error code)
No SD memory card is found. Insert an SD memory card into the SD card slot or reinsert it correctly.
The write-protect switch on the SD memory card is in the “PROTECTED” position. Set the switch on the
“NOT PROTECTED” position.
The SD memory card is full. Delete unwanted data from the card on a PC or replace the card with a new
one. When using a new SD memory card, be sure to format it in advance.
The SD memory card has no desired data. Replace it with another SD memory card containing the
desired data.
The data stored in the SD memory card is incorrect. Write correct data into the SD memory card on a
PC.
The maximum allowable number of times of sales data or EJ data writing is exceeded. Delete unwanted
data from the SD memory card on a PC or replace the card with a new one. When using a new SD
memory card, be sure to format it in advance.
A power failure has occurred while the SD memory card is accessed. Perform the interrupted operation
again from the beginning after power recovery.
An error other than the above mentioned has occurred while the SD memory card is accessed. Perform
the interrupted operation again from the beginning.
A22S_5 FOR THE MANAGER_SD 09.10.16 5:42 PM Page 65