Sharp CD2200M - Manual (Page 13)

EN-12
PROGRAM & CUSTOMIZE
Custom Help
You can check your oven settings and customize your
oven by changing Custom Help settings.
The CUSTOM HELP pad has 11 operations.
1. Selecting Memory Input Method
2. Selecting Auto Start Operation
3. Program Lock Setting
4. Audible Signal Sound Volume Setting
5. Cooking Completion Signal Setting
6.
Memory Check
7. Counter Check/Clear
8. Air Intake Filter Counter
9. Selecting Operation in case of Magnetron Failure
10. Multiplication Factors for Double/Triple Quantity
11. Express Defrost Setting
To use Custom Help Function, press the CUSTOM HELP
pad twice within 2 seconds, and desired option pads.
See detailed instructions below.
NOTE : You will hear an audible signal the second time
the CUSTOM HELP pad is pressed to indicate that you
have entered Custom Help.
1. Selecting Memory Input Method
Your oven has 3 ways to select memory numbers.
CH11 : Dual Digit Input (100 memory banks)
= Factory Setting
CH12 : Single Digit Input (10 memory banks)
CH13 : Repeat Digit Input (30 memory banks)
To set Input Method
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
1,1 for Dual Digit Input
1,2 for Single Digit Input
1,3 for Repeat Digit Input
Press the START pad to save settings and the STOP/
CLEAR pad to exit from the Custom Help Function.
* Suppose you want to set Repeat Digit Input.
x 2
Procedure
1 3
STOP
CLEAR
1 Press the CUSTOM HELP pad
twice within 2 seconds.
2 Enter 1,3 for Repeat Digit
Input.
3 Press the START pad to save
the setting. START
4 Press the STOP/CLEAR pad
to exit from the Custom Help
function.
CUSTOM
HELP
2. Selecting Auto Start Operation
Your oven has 2 ways to start memory cooking.
CH21 : Auto Start OFF = Factory Setting
CH22 : Auto Start ON
The factory setting is Auto Start OFF. Under Auto Start
OFF, cooking will not begin until the START pad is
pressed. Under Auto Start ON, cooking will automatically
start after the memory number is input.
To set AUTO START
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
2, 1 for Auto Start OFF
2, 2 for Auto Start ON
Press the START pad to save settings and the STOP/
CLEAR pad to exit from the Custom Help Function.
* Suppose you want to set Auto Start ON.
Procedure
2 2
STOP
CLEAR
x 2 CUSTOM
HELP
1 Press the CUSTOM HELP pad
twice within 2 seconds.
2 Enter 2, 2 for Auto Start ON.
3 Press the START pad to save
the setting. START
4 Press the STOP/CLEAR pad
to exit from the Custom Help
Function.
3. Program Lock Setting
You can select Program Lock ON or OFF
CH31 : Program Lock OFF = Factory Setting
CH32 : Program Lock ON
Program Lock OFF is the Factory setting. Program Lock
prevents accidental changes to settings. When the
CUSTOM HELP pad is pressed twice within 2 seconds
in program Lock ON, the LOCK indicator will light up.
Turn Program Lock OFF when you want to change the
settings.
To turn Program Lock ON/OFF
Press the CUSTOM HELP pad twice within 2 seconds then
enter the numbers
3, 1 for Program Lock OFF
3, 2 for Program Lock ON
Press the START pad to save settings and the STOP/
CLEAR pad to exit from the Custom Help Function.