Shindaiwa GP3410 - Manual (Page 11)

50-hour Maintenance
Every 50 hours of operation
(more frequently in dusty or dirty
conditions):
Remove and clean the cylinder cover
and clean dirt from the cylinder fins.
Use a hooked wire to extract the fuel filter
from inside the fuel tank. See Figure 5.
.
.
CAUTION!
Make sure you do not pierce the
fuel line with the end of the hooked
wire. The line is delicate and can be
damaged easily.
Every 10 to 15 hours of operation:
CAUTION!
Before removing the spark plug,
clean the area around the plug to
prevent dirt and debris from getting
into the engine’s internal parts.
Clean the spark plug
and check the gap at
the electrode.
10/15-Hour Maintenance
0.024–0.028 inch
(0.6–0.7 mm)
Figure 14
NOTE:
The NGK CMR5H also meets the
requirements for electro magnetic com-
pliance (EMC).
Remove and replace the filter element.
Before reinstalling the new filter ele-
ment, inspect the condition of all the fuel
system components (fuel pick-up line,
fuel return line, tank vent line, tank vent,
fuel cap and fuel tank). If damage, split-
ting or deterioration is noted, the unit
should be removed from service until it
can be inspected or repaired by a Shin-
daiwa-trained service technician.
3.
Filter Element
Hooked
Wire
Figure 15
Remove and clean the spark plug.
Adjust the spark plug electrode gap to
0.04 - 0.08 inch (0.6 - 0.7 mm). If the
spark plug must be replaced, use only
an NGK CMR5H or equivalent resis-
tor type spark plug of the correct heat
range. See Figure 4.
■
Maintenance (continued)