Stanton STR8-90 User Manual
Page 4
SCRATCH PROTECTION
The STR8-90 includes a
pair of rubber protectors.
These were designed to
protect the turntable’s
rounded aluminum edges
from the mixer while
scratching. When the
turntables are placed
sideways, the round edges
of the turntable may come
in contact with the mixer’s
rack ears causing damage
to the turntable body. Placing the rubber protectors on the mixer rack
ears (see picture) will prevent the turntable from getting scratched.
WARRANTY
This unit has been designed and manufactured using quality components.
Therefore, it is warranted to be free from defects in materials (limited as
specified below), and workmanship for a period of twelve (12) months
from the original purchase date. During this period, all service and parts
necessary to repair a defect will be free of charge. This limited warranty
applies to mechanical parts which are subject to wear and tear as
specified: Faders, specified durability: 50,000 cycles; 10,000 cycles;
Switches, specified durability: 10,000 cycles. Consequently, the parts
listed above are warranted to be free from defects in materials and
workmanship for a period of thirty days (30) days from the original
purchase date.
Note: For the warranty to be valid, please complete the online
warranty registration form found at www.stantonmagnetics.com.
Stanton Magnetics, INC. 3000 SW 42
nd
Street x Hollywood, FL 33312
Tel: (954) 689-8833 Fax: (954) 689-8460
Email: [email protected]
SPECIFICATIONS
TURNTABLE SECTION
Starting Torque:
More than 2.2kgf.com
Motor:
16pole, 3phase, brushless DC motor
Platter:
330mm dia. Aluminum diecast
Pitch: +/-8%,+/-16%,+/-25%
Brake: Electronic
brake
TONE ARM SECTION
Tone arm type
Static balanced straight
tonearm with Cardan suspension
Effective Arm Length
191mm
Tracking Force Adjust Range
0-4g
Applicable Cartridge Weight
6-10g
Frequency Response
20 - 20 kHz
Channel Separation
More than 15 dB
Channel Balance
Within 2.5dB at 1 KHz
Wow & Flutter:
Less than 0.20% WRMS
(JIS WTD) with 33 1/3rpm
S/N ratio:
More than 50dB (DIN-B)
Needle Pressure range
1.5-2g
GENERAL SPECIFICATIONS
Dimensions:
450(W) x 370 (D) x 140 (H)mm
17-3/4" x 14-5/8" x 5.5" (WxDxH)
Weight:
9.9Kg (21.8 lbs.)
Power supply:
AC 100V, 50/60Hz
Power consumption:
12W