Sanyo PLC-WL2500 - Manual (Page 35)

5
ENGLISH
System
This function is to select the system of signal
input to the projector. The available system
mode are listed on the pull-down menu but-
ton according to the input signal. Select a
system and then click Set button.
Control
✐ If the mode (Mode1 to Mode10) which is stored in the item "PC Adjustment" (+ p.38) is available,
they are also listed together with the above mode.
Available selection at the RGB input
Item Description
XGA1 ........................ It automatically switches to the proper computer
system of the input signal.
* The computer system modes (VGA, SVGA, XGA.
SXGA, UXGA, WXGA...) which meet the input sig-
nal are listed.
Available selection at the Video/S-video/Scart input
Item Description
AUTO ........................ It automatically switches to the proper color sys-
tem of the input signal.
* The selectable color systems are PAL, SECAM,
NTSC, NTSC4.43, PAL-M and PAL-N.
* AUTO is fixed at the Scart input.
Available selection at the Component input
Item Description
AUTO ........................ It automatically switches to the proper scanning
system of the input signal.
* The selectable scanning systems are 480i, 575i,
480p, 575p, 720p, 1035i and 1080i.
Available selection at the HDMI input
Item Description
D-XGA ...................... It automatically switches to the proper computer
system of the input signal.
* The computer system modes (D-VGA, D-SVGA,
D-XGA. D-SXGA1...) which meet the input signal
are listed.
D-480p .................... It automatically switches to the proper scanning
system of the input signal.
* The selectable scanning systems are D-480p,
D-575p, D-720p, D-1035i and D-1080i.