Sagem ITD 60 - Manual (Page 27)

- 21 -
7. USING YOUR SET TOP BOX
7-12 RADIO MODE
Press the key on the remote control unit of the Set Top
Box.
You can move through the list displayed using and
.
You can adjust the volume with and .
7-13 SET TOP BOX ENHANCEMENT
The Set Top Box goes in this state when a new version of software is available on the network after startup.
• Red led flashes.
• The Welcome screen is displayed.
Then a screen for “download process” request is displayed.
You can delay the downloading process by pressing the EXIT
key. This process will be displayed again the next time you
switch on your Set Top Box. When pressing the key, the
downloading will be performed:
• Then the screen becomes black,
• Flash on led.
During this mode, no action from the user is authorized.
Once the process is completed, the receiver will switch on
automatically. After startup an information screen is displayed
on download completed. Then press
and enjoy with
your last viewed program.
Note: if the download process is not correctly performed, the
screen stays black and the green led flashes indicating the
cause of the failure (see table below).
When an error occurs, press any key on the remote to
continue. Then put the Set Top Box in standby mode and
switch it back on to perform downloading again.
If this operation does not succeed, unplug the main cord and
the antenna cord. Then plug them again to perform
downloading again.
DOWNLOAD PROCESS
IN ORDER TO IMPROVE THE BOX FONCTIONNALITIES
A DOWNLOAD OF SOFTWARE IS NECESSARY.
IT TAKES A FEW MINUTES.
DURING THE DOWNLOAD
YOUR SCREEN WILL BE BLACK.
DO NOT SWITCH OFF YOUR BOX
DURING THIS TIME.
TO RECEIVE THIS UPDATE
PRESS OK OTHERWISE EX TO EXIT.
DOWNLOAD PROCESS
DOWNLOAD COMPLETED
NEW S/W DOWNLOAD
IS SUCCESSFUL
TO RETURN TO YOUR PROGRAMME
PRESS OK