5 changing installation code, User settings – Sagem ITD 60 User Manual
Page 20
- 14 -
6. USER SETTINGS
6-5 CHANGING INSTALLATION CODE
To go main MENU/INSTALLATION/USER SETTINGS/CHANGING INSTALLATION CODE
Enter your new code.
As soon as the value has been entered, the segment is
replaced with a star.
Use cursor
on the remote control unit to come back to a
value that has been entered and modify it.
In this case, the value becomes a blinking segment again,
indicating that entry is possible.
Enter the same new code to confirm it.
"CORRECT" appears, the code is validated automatically.
If you have not entered the right code, you will see the error
message according to appearing "BAD CODE
CONFIRMED", enter again the code.
Note: use value “0000” if you do not want to enter any protection code.