Samsung VP-D200 - Manual (Page 24)

ENGLISH
Preparation
24 24
Using the Lithium Ion Battery Pack
✤ The amount of continuous recording time available depends on.
-
The type and capacity of the battery pack you are using.
- How often the Zoom function is used.
It is recommended that you have several batteries available.
Charging the Lithium Ion Battery Pack
1. Attach the battery pack to the camcorder.
2. Connect the AC Power adapter to an AC cord and connect the AC
cord to a wall socket.
3. Connect the DC cable to the DC jack socket on the camcorder.
4. Turn the Camera power switch to off, and the charging indicator will
start to flash, showing that the battery is charging.
5. When the battery is fully charged, disconnect the battery pack and the AC Power adapter from the camcorder.
■ Even with the power switched off, the battery pack will still discharge if it is left connected to the camcorder.
Notes
■ The battery pack may be charged a little at the time of purchase.
■ To prevent reduction in the life and capacity of the battery pack, always remove it from the camcorder after
it is fully charged.
Blinking time Charging rate
Once per second Less than 50%
Twice per second 50% ~ 75%
Three times per second 75% ~ 90%
Blinking stops and stays on 90 ~ 100%
On for a second and Error - Reset the battery pack and
off for a second the DC cable
TAPE EJECT VOL/M
CHARGE
5
00709E VP-D230(i) UK (01~27) 9/1/04 10:26 AM Page 24