Shindaiwa MULTiPURPOSE TOOL CaRRiER M254 - Manual (Page 6)

6
4 - 6 mm
Outer tube
Hex screws
Handle
Moutning
plate
Throttle assembly
Adjusting the handle
4 - 6
mm
Loosen the fasteners on the air filter cover
Adjusting throttle trigger free play
assembly and adjustments
Prior to assembly
This Shindaiwa Multipurpose Tool Car-
rier comes fully assembled. You only
need attach the accessory tool of your
choice to the powerhead. Your Multi-
purpose tool carrier includes:
iMPORTanT!
The terms “left”, “left-hand”, and
“LH”; “right”, “right-hand”, and “RH”;
“front” and “rear” refer to directions as
viewed by the operator during normal
operation.
Throttle trigger free play
The throttle trigger free play should be
approximately 4 - 6 mm. Make sure that
the throttle trigger operates smoothly
without binding. If it becomes neces-
sary to adjust the trigger free play,
follow the procedures and illustrations
that follow.
1. Loosen the air cleaner cover knobs
and remove the air cleaner cover.
2. Turn the cable adjuster in or out as
required to obtain proper free play
4-6 mm (3/16-1/4 inch).
3. Reinstall the air cleaner cover.
■
Operator’s manual
■
Assembly Tool(s)
handle
Your Shindaiwa Multi-Purpose Tool
Carrier comes with the handle
installed. It can be re-adjusted for oper-
ator comfort in the following manner.
1. Loosen the four hex screws..
2. Rotate/slide handle assembly to best
position for operator comfort, usually
25 cm (10 in.) ahead of the throttle
assembly.
3. Tighten hex screws in a crisscross
manner.
Cable
Adjuster