Shindaiwa MULTiPURPOSE TOOL CaRRiER M254 - Manual (Page 5)

5
Specifications
Engine Model M254
Dry weight (Including attachments) 4.5 kg / 9.9 lb.
Engine type 4-cycle, vertical cylinder, air cooled
Bore x stroke 34 x 27 mm / 1.3 x 1.1 in.
Displacement 24.5 cc / 1.5 cu. in.
Fuel/oil ratio 50:1 with *ISO-L-EGD or JASO FD class engine oil*
Carburetor type Diaphragm-type
Fuel tank capacity 590 ml / 20.0 oz.
Ignition One-piece electronic, program contolled
Spark plug* NGK CMR5H
Electrode Gap 0.6 mm / .024 in.
Torque 16.7 - 18.6 N∙m / 148-165 in • lbf
Air cleaner type Foam pre-filter; sealed felt main filter
Starting method Recoil
Stopping method Slide switch
Transmission type Automatic, centrifugal clutch w/bevel gear
Idle Speed 2,900 RPM
Clutch Engagement Speed 4,100 RPM
Wide Open Throttle Speed (W.O.T.) 9,600 RPM
Specifications are subject to change without notice.
An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY; information on label varies by engine
FAMILY).
PROdUCT EMiSSiOn dURaBiLiTY (EMiSSiOn COMPLianCE PERiOd)
The 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine emissions
output meets applicable emissions regulations, provided that approved maintenance procedures are followed as listed in
the Maintenance Section of this manual.
Emission Control (Exhaust & Evaporative)
EPa 2010 and Later and/or C.a.R.B. TiER iii
The emission control system for the engine is EM (engine modification) and, if the second to last character of the Engine
Family on the Emission Control Information label (sample below) is “C”, “K”, or “T”, the emission control system is EM and
TWC (3-way catalyst). The fuel tank/fuel line emission control system is EVAP (evaporative emissions). Evaporative emissions
for California models may only be applicable to fuel tanks.