Woodstock W2000 - Manual (Page 10)

W2000 Rebel ® – 9
Although the power switch on your router can be
turned on and off each time you use The Rebel
® , the
optional switch (Item Number W2001) offers greater
convenience and safety. The optional switch is avail-
able through your retailer.
The switch assembly consists of a guarded rocker type
switch with removable key, three prong 110 volt
female cord and three prong 110 volt male power cord.
Step 1 - Mount the electrical switch in the right front
leg opening. To mount the switch, feed the
male and female cords through the leg open-
ing and snap the switch plate into place.
Figure 9.
E. Electrical Switch (optional)
Figure 9. Installing the switch.
Figure 10. Attaching the grounding ring terminals.
Step 2 - The two grounding terminals must be
attached to the Rebel ® frame. Remove any
convenient socket head cap screw attaching
the leg to the tabletop. Overlap the two ring
terminals connected to the end of the two
grounding (green) wires. Insert the socket
head cap screw through the ring terminals and
re-fasten to the tabletop. Figure 10.
Grounding
Ring
Terminals
The Rebel ® must be electrically grounded when
using the optional switch. Failure to attach the
grounding terminal to the Rebel
® frame may
result in serious personal injury.
F. Mounting the Router
Figure 11. Removing sub-base from router.
Attaching your router to The Rebel ® is very easy.
When using your router in The Rebel ® you must
follow all safety recommendations by the router man-
ufacturer.
Step 1 - Remove the existing router sub-base that is
attached to your router base. Figure 11.