Sanyo SM-GA0005 User Manual
Page 3
2
S
S
A
A
F
F
E
E
T
T
Y
Y
P
P
R
R
E
E
C
C
A
A
U
U
T
T
I
I
O
O
N
N
S
S
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO
AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY
A. Do not operate or allow the oven to be operated with the door open.
B. Make the following safety checks on all ovens to be serviced before activating the magnetron or
other microwave source, and make repairs as necessary.
(1). Interlock operation
(2). Proper door closing
(3). Seal and sealing surfaces (arcing, wear, and other damage).
(4). Damage to or loosening of hinges and latches.
(5). Evidence of dropping or abuse.
C. Before turning on microwave power for any service test or inspection within the microwave
generating compartments, check the magnetron, wave guide or transmission line, and cavity for
proper alignment, integrity, and connections.
D. Any defective or misaligned components in the interlock, monitor, door seal and microwave
generation and transmission systems shall be repaired, replaced, or adjusted by procedures
described in this manual before the oven is released to the owner.
E. A microwave leakage check to verify compliance with the Federal performance standard should be
performed on each oven prior to release to the owner.
THIS MANUAL, AS WELL AS THE INFORMATION CONTAINED IN IT, IS TO BE USED ONLY BY AN
AUTHORIZED SERVICE TECHNICIAN FAMILIAR WITH AND KNOWLEDGEABLE OF PROPER
SAFETY AND SERVICING PROCEDURES AND POSSESSING HIGH QUALITY TEST EQUIPMENT
ASSOCIATED WITH MICROWAVE AND ELECTRICAL APPLIANCE REPAIR.
ALL INDIVIDUALS WHO ATTEMPT REPAIRS BY IMPROPER MEANS OR ADJUSTMENT SUBJECT
THEMSELVES AND OTHERS TO THE RISK OF SERIOUS OR FATAL INJURY.