Sanyo SM-GA0005 User Manual
Page 16
15
earthing screw
fuse housing
power supply cord
Fig.4-12
Fig.4-15
diode
capacitor
fan holder
screw
capacitor
transformer
H.V.fuse
Fig.4-16
magnetron
diode
1.
Assemble the fan motor as FIG.4 – 14. Drip the glue on
the “★” place of the fan motor shaft, and fix the fan on the
motor, make sure it must be fixed to the bottom of the
shaft. Attention: The fan motor shaft should not be curved,
the fan should have no abnormal stick up. After assembled,
check whether the running fan would knock the fan holder.
2.
Assemble the fan holder as FIG.4 – 13, Then connect the
power supply cord with the two wires of the fan motor, and
tighten the screws as FIG.4 – 11 and FIG.4 – 12.
4
4
.
.
7
7
T
T
H
H
E
E
C
C
A
A
P
P
A
A
C
C
I
I
T
T
O
O
R
R
.
.
Firstly, do as the 1, 2, 3, steps of Ⅲ of this part.
To disassemble,
1.
Pull the wires of the capacitor out (4-15).
2.
Loosen and take out the screw which fix the capacitor clip
with a “+” – screwdriver, and take out the clip and the
capacitor. (4-15).
To assemble,
1.
Place the capacitor in the capacitor clip with the end which
have three foot near the diode (4-16).
2.
Insert one end of the clip in the fan holder trough (FIG.4-15).
3.
Tighten the screw, which fix the capacitor clip.
4.
Plug in all the plugs of the capacitor.
4
4
.
.
8
8
T
T
H
H
E
E
D
D
I
I
O
O
D
D
E
E
.
.
Firstly, do as the 1, 2, 3, steps of Ⅲ of this part.
To disassemble,
1.
Pull out the diode plug, which plugged in the
capacitor.
2.
Loosen the screw, which fixed the diode, and
take the diode off.
To assemble,
Fig.4-13
screw
fan motor
back board
Fig.4-14
fan