Samsung 1100DF - Manual (Page 59)

Check List
Q & A
Self-Test Feature
Check
General Q & A | Highlight Zone II Q & A | MouScreen Q & A
1. General Q & A
Question Answer
How can I change the frequency? Frequency can be changed by reconfiguring the video
card.
Note that video card support can vary, depending on the
version of the driver used.
(Refer to the computer or the video card manual for
details.)
How can I adjust the resolution? Windows ME/XP/2000: Set the resolution at the Control
Panel, Display, Settings.
* Contact the video card manufacturer for details.
How can I set the Power Saving
function?
Windows ME/XP/2000: Set the function at BIOS-SETUP
of the computer or the screen saver. (Refer to
Windows/Computer Manual).
The monitor makes a sound when it
is turned on. This is normal as some sound may be generated when
the metal case and the electromagnet, which are installed
to block any electromagnetic waves, interact with each
other.
How can I clean the outer
case/Picture tube? Disconnect the power cord and then clean the monitor
with a soft cloth, using either a cleaning solution or plain
water.
Do not leave any remains of the detergent nor scratch the
case. Do not allow any water to go inside the monitor.
2. Highlight Zone II Q & A
Question Answer
The program does not function
properly.
Highlight Zone II features a combination of circuitry and
software built on proprietary technology of SEC and
deploys USB for data communication. Therefore, the
Highlight Zone II feature is found only on SEC monitors
that support the feature and are equipped with a USB
port.
Check if your monitor supports the Highlight Zone II
feature.
Make sure the USB port connection is correct and
secure.
If not, the Highlight Zone II icon will show a message
saying, "USB Not Connected" (
)Connect the monitor
properly before using it. Neither Automatic Detect or nor
Manual Detect function while the icon shows the
message, "USB Not Connected". You can only exit the
program.