Sony HT-SF1200 - Manual (Page 63)

63 GB
D:\Chin Meng's job\SONY-HA\HT-SF1200_R2\1200_data\3210767121\GB06OTH_HT-SF1200-
CEL.fm masterpage: Right
[HT-SF1200/HT-SS1200]
3-210-767-12 (2)
Ad
dit
ion
al I
n
fo
rmatio
n
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see “When error codes
appear” (page 26) to solve the problem.
PROTECT
Irregular current is output from the
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 22). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
Specifications
Amplifier section
Power Output 1)
Stereo mode (rated) 108 W + 108 W
(3 ohms at 1 kHz,
THD 1%)
Surround mode (reference)
RMS Output
(3 ohms at 1 kHz,
THD 10%)
FRONT
2) : 143 W/ch
CENTER 2) : 143 W
SUR 2) : 143 W/ch
(1.5 ohms at 80 Hz,
THD 10%)
SUBWOOFER
2) : 285 W
1) Measured under the following conditions:
2) Reference power output for front, center, surround
speakers and sub woofer. Depending on the sound
field settings and the source, there may be no
sound output.
Inputs
Analog Sensitivity: 1 V/50 kohms
Digital (Coaxial) Impedance: 75 ohms
Tone
Gain levels ±10 dB, 0.5 dB step
Reproduction frequency range:
28 – 20,000 Hz
FM tuner section
Tuning range 87.5 – 108.0 MHz
Antenna FM wire antenna
Antenna terminals 75 ohms, unbalanced
Intermediate frequency
10.7 MHz
To clear See
All memorized settings page 22
Customized sound fields page 47
Area code Power requirements
CEL, CEK 230 V AC, 50 Hz
continued