Spirit IN400T - Manual (Page 17)

Before contacting your dealer for aid, please review the following information. It may
save you both time and expense. This list includes common problems that may not be
covered under the treadmill’s warranty.
PROBLEM SOLUTION/CAUSE
Display does not light
Treadbelt does not
stay centered
Treadmill belt hesitates
when walked/run on
Motor is not
responsive / Display
is lit
Treadmill will only
achieve approximately
7 mph but shows
higher speed on dis-
play
Treadbelt stops
quickly/suddenly when
tether cord is pulled
Treadmill trips on
board 15 amp circuit
breaker when running/
walking
Computer shuts off
when console is
touched (on a cold day)
while walking/running
Tether cord not in position.
Circuit breaker on front grill tripped. Push circuit breaker in until it locks.
Plug is disconnected. Make sure plug is firmly pushed into AC
household wall outlet.
Household circuit breaker may be tripped.
Treadmill defect. Contact your Spirit dealer.
See General Maintenance section under Belt Tracking.
A user may be walking while favoring or putting more weight on either
the left or right foot. If this walking pattern is natural, track the belt
slightly off-center to the side opposite from the belt movement.
See Maintenance section on Treadbelt Tension. Adjust as necessary.
Make certain clock is running. This indicates motor should be
receiving power to operate. Contact your Spirit dealer. Diagnostics
will indicate if warrantable.
Possible treadmill defect. Contact your Spirit dealer. Diagnostics
will indicate if warrantable.
Low AC voltage to treadmill. Do not use an extension cord. If an
extension cord is required it should be as short as possible and
heavy duty 16 gauge minimum.
Low household voltage. Contact an electrician or your Spirit dealer.
A minimum of 110 volt AC current is required.
High belt/deck friction. See General Maintenance section on lubrication.
High belt/deck friction. See General Maintenance section on lubrication.
Treadmill is not grounded. Static electricity is “crashing” the com-
puter. Refer to Grounding Instructions on page 3.
15
Service Checklist - Diagnosis Guide