Sharp MD-MX30 MD - Manual (Page 10)

9
(Continued)
To AC INPUT
AC 120 V, 60 Hz
To an AC outlet
■ Removing the speaker grilles ■ Connecting the AC power cord
Connect the AC power cord to the AC INPUT jack, then
connect its plug to an AC outlet.
Notes:
● Unplug the AC power cord from the AC outlet if the unit will
not be in use for a prolonged period of time.
● Never use a power cord other than the one supplied. Use
of a power cord other than the one supplied may cause an
electric shock or fire.
■ Demo mode
4" (10 cm) 4" (10 cm)
4" (10 cm)
4" (10 cm)
1
Remove the lower part of the speaker grille first.
2
Remove the upper part of the speaker grille.
Caution:
When the speaker grilles are removed, the speaker dia-
phragms are exposed. Make sure nothing comes into contact
with the speaker diaphragms.
■ Speaker cushion
Attach the cushions to the bottom of the speaker to pre-
vent it from sliding.
■ Placing the system
Be sure to keep space between the units for ventilation.
Keep the top and the back of this unit at least 4" (10 cm)
away from the wall.
DISPLAY
(DEMO)
When the AC power cord is first connected, the unit will
enter the demonstration mode and the words will scroll
across the display continuously.
To cancel the demonstration mode:
When in the demonstration mode, press the DISPLAY (DEMO)
button.
● The demonstration mode will be canceled and the unit
will be in the low power consumption mode.
Note:
● When the unit is in the low power consumption mode, the
display will disappear.