Sanus Systems VISIONMOUNT VMXA1 - Manual (Page 2)

Using the previously removed Flange Nuts and Nylon Washers, secure the Right and Left Extension to the VMXA1 as shown in Diagram
1D, and securely tighten the Flange Nuts.
Diagram 1D
Flange
Nut
Nylon
Washer
Left
Extension
VMXA1
Right
Extension
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 08.2.06 (100042)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Separate the Left and Right Extension of the Wall Plate Assembly ( A) and set them to so that their outer edges are equal to the desired
width.
NOTE: All four of the Threaded Studs must pass through the VMXA1 for the installation to be safe.
Insert the VMXA1 so the teeth on its bottom fit into the slots in the Left and Right Extension, making sure that the Threaded Studs fit
through the center row on holes in the VMXA1 as shown in Diagram 1C.
Diagram 1C
Left
Extension
VMXA1
Right
Extension
Threaded
Studs