Sharp TINSE2026QSZZ - Manual (Page 96)

94
SYSTEM SETTINGS (GENERAL)
EXECUTING A JOB PROGRAM
1 Press the [#/P] key ( ).
2 Touch the program number key of the
desired program.
The job program will be
executed. A number for
which no job program
has been stored cannot
be selected.
3 Place the original, check the original
size, and then set the number of
copies and any other desired copy
settings not stored in the program.
When finished, press the [START] key
(
).
DELETING A STORED JOB PROGRAM
1 Press the [#/P] key ( ).
2 Touch the [STORE/DELETE] key.
3 Select the program number of the
program to be deleted.
If a number key for which
no job program has been
stored is selected, the
proceed to step 4 on the
previous page (for
storing a job program).
4 Touch the [DELETE] key.
The selected program will
be deleted and you will
return to the screen of step
3. If the [CANCEL] key is
touched, you will return to
the screen of step 3
without deleting the
program.
If you are finished deleting programs, touch the [EXIT]
key in the screen of step 3 to exit.
LOGOUT
JOB PROGRAMS
PRESS PROGRAM NUMBER.
RECALL
UT
LOGOUT
LOGOUT
NUMBER.
ECALL STORE/DELETE
EXIT
STORE/DELETE
RECALL STORE/DELET
A JOB PROGRAM HAS BEEN ALREADY STORED.
STORE ANOTHER PROGRAM?
CANCEL DELETE STORE
MX-M310.book 94 ページ ２００９年７月６日 月曜日 午後６時５７分