Southbend SGS-48E - Manual (Page 8)

I NSTALLATION C OUNTER G RIDDLE
P AGE 8 O PERATOR ’ S M ANUAL 1182629 REV 2
IN
S
TA
LLA
TI
ON
Step 2a: Installation on Countertop Legs
To install the griddle using countertop legs, do the following:
1. Locate the box of four legs shipped with the griddle (if countertop legs were ordered).
2. Raise the griddle about 6" so that the legs can be screwed into the bottom near the corners. Lift the
griddle only from the ends, never from the middle! Support the lifted griddle so that it will not fall while
you are attaching the legs.
3. Screw the four legs into the threaded holes located on the bottom of the griddle near each corner (as
shown in Figure 3 below).
4. Gently lower the griddle onto the counter. Level the griddle surface by screwing one or more of the legs
in or out.
5. Go on to Step 4 on page 16.
Figure 3