Southbend SGS-48E - Manual (Page 11)

C OUNTER G RIDDLE
I NSTALLATION
O PERATOR ’ S M ANUAL 1182629 REV 2 P AGE 11
IN
S
TA
LLA
TI
ON
Step 2d: Installation on Floor Stand (24", 36", and 48" Models)
The 24", 36", and 48" griddles may be installed on top of an optional floor stand (for 60" griddles, go to Step
2e on page 13). The floor stand is shipped in a separate crate and must be assembled, as follows:
1. Position the bottom-brace pieces on a flat surface, as shown in Figure 6 below. There are two bottom-
side braces (items “A”), a bottom-front brace (item “B”), and an identical bottom-rear brace (item “B”).
2. Position a corner brace (item “C”) in each corner, matching the pre-punched holes on the lower inside
flange of the bottom braces.
3. Position a leg bracket (item “D”) into each corner. Be sure that the bracket flanges are engaged into the
open hem of the bottom braces.
4. Use the sixteen 1/2"-long hex head bolts (items “E”), lock washers (items “F”), and acorn nuts (items “G”)
to bolt the corner braces to the bottom braces. Only hand-tighten for now.
5. Check that the leg brackets are in the proper position, and that the outside corners are square.
Figure 6
G
F
E
A
D
C
B
D
C
A
6. Use the eight 1-1/2" hex bolts (items “H” in Figure 7) to attach the two left-legs (items “I”) and the two
right-legs (items “J”). “Left” and “right” are as seen from the front or rear of the stand. Be sure that the
small threaded-insert near the top of each leg faces either the front or the rear of the stand, not a side.
Insert the bolts through the leg brackets and into the legs. Only hand-tighten the bolts for now.