Southbend SGS-48E - Manual (Page 27)

C OUNTER G RIDDLE
P ARTS
O PERATOR ’ S M ANUAL 1182629 REV 2 P AGE 27
PA
RT
S
P
ARTS
NOTICE
INSTALLATION OF OTHER THAN GENUINE SOUTHBEND PARTS WILL VOID THE WARRANTY
ON THIS EQUIPMENT.
The serial plate is located inside of the control panel on the front of the griddle (see Figure 1 on page 3).
Replacement parts may be ordered either through a Southbend Authorized Parts Distributor or a Southbend
Authorized Service Agency.
When ordering parts, please supply the Model Number, Serial Number, Part Number, and Description.
For parts not listed, consult a Southbend Authorized Parts Distributor or Southbend Authorized Service
Agency. Consult the Southbend Authorized Parts/Service Distributor list for the Authorized Parts supplier in
your area. If this list is not available, call Southbend at 1-800-348-2558 to obtain this list.
Except where the a part number is explicitly associated with a particular model number, all parts listed are
used by all the models covered by this manual: SGS-24, SGS-24E, SGS-36, SGS-36E, SGS-48, SGS-48E,
SGS-60, and SGS-60E. (An “E” suffix on a model number indicates that the model is equipped with
electronic ignition for lighting the pilots.)
Index of Parts Diagrams
Page Number Description
28 Chassis Parts
30 Gas System Parts
32 Floor Stand Parts for 24", 36", and 48" Width Griddles
34 Floor Stand Parts for 60" Width Griddles
36 Countertop Legs and Insulated-Base Parts