Sherwood DD-6200 - Manual (Page 16)

Troubleshooting Guide
2 1 6
If your unit should not perform as expected, consult the table below to see if the problem can be corrected before
seeking help from your dealer or our service organization.
PROBLEM POSSIBLE CAUSE REMEDY
No power The AC input cord is disconnected.
The POWER switch is not pressed
completely. Connect the cord securely.
Press the POWER switch to ON.
Distorted or abnormal
sound Dirty head.
Incorrect selection of the Dolby NR
system.
The tape is stretched or wrinkled. Clean the head.
Select the Dolby B NR or the Dolby
NR OFF mode.
Replace the tape.
Vibrating sound Dirty capstans or pinch rollers.
The tape is irregularly wound. Clean the capstans or pinch rollers.
Wind the tape by advancing or
rewinding rapidly.
Too noisy Magnetized head.
Poor connections. Demagnetize the head.
Check the connections and connect
all cords securely.
Not recording The tabs have been removed.
Dirty head. Cover with the adhesive tape.
Clean the head.
No sound Unrecorded tape is loaded.
Incorrect connections.
Incorrect operation of the amplifier. Load the recorded tape.
Make connections correctly.
Operate the amplifier correctly.