Sony WEGA KV-27FS13 - Manual (Page 50)

Cable stations
Make sure Cable is set to ON in the Channel Setup
don’t seem to
menu (page 26).
work Perform Auto Program to add channels that are not
presently in the memory (page 17).
Remote control
Batteries could be weak. Replace them (page 2).
does not Cl
operate
Move the TV 3-4 feet away from fluorescent lights.
Cannot change
Make sure you’have not switched your
channels with
TV from the channel 3 or 4 setting if you are using
the remote
another device to change channels.
control If you are using another device to control channels, be
sure the FUNCTION button for that device has been
pressed. For example, if you’re using your VCR to
control channels, be sure to press the VCR/DVD
FUNCTION buttons (page 15).
The TV needs
Clean the TV with a soft dry cloth. Never use strong
to be cleaned
solvents such as thinner or which might
damage the finish of the cabinet.
In the password screen; enter the following master
for Parental
password: 4357. After using the master password, you
Control
must create a new password; it cannot be used to
unlock currently blocked channels.
access
.
If you use the
other menus
button to close the Basic menu, only.
the Basic menu appears when you press again. To
when using the
have access to the other menus, use the button to
Basic Menu
select Advanced Menu (page 36).
The remote
Press the TV FUNCTION button. You may have
control won’t
work in PIP
mode
is
window picture
or it is just
static
inadvertently pressed the
button, which changes the PIP buttons to VCR mode
Be sure your picture is set to a video source/
channel that has a program airing.
You may be tuned to a video input with nothing
connected to it. Try cycling through your video inputs
using the yellow PIP TV/VIDEO button with the red
dot (page 18).
PIP is not set to receive a signal from the AUX input.
you have connected a VCR, DVD or Satellite Receiver
to the AUX input on the TV, it will not show in the
small window picture.
. . .