Sennheiser EK 500 G2 - Manual (Page 14)

14
Using the receiver
Switching the receiver on/off
The receiver can only be switched off when the standard
display is shown on the display panel. When in the
operating menu, briefly pressing the
ON / OFF
button will
cancel your entry (ESC function) and return you to the
standard display with the last stored settings.
Note:
Remove the batteries or the accupack when the receiver
will not be used for extended periods of time.
̈
Press the two unlocking buttons
µ
and open the
battery compartment cover
¾
.
̈
Press the ON / OFF button
¸
to switch the receiver on.
The red LED
»
lights up.
̈
To switch the receiver off, press the ON / OFF button
¸
until “OFF” appears on the display. The red LED
»
goes
off.
̈
Close the battery compartment. The battery
compartment cover
¾
locks into place with an audible
click.
Connecting the headphones
̈
To monitor the audio signal, connect headphones with a
3.5 mm jack plug to the headphone output (PHONES)
ᕡ
.
µ
¾
¸
»
³