Sennheiser EK 500 G2 - Manual (Page 12)

12
are corrected correspondingly. Due to the missing sen-
sor, individual rechargeable battery cells will not be
identified as accupacks.
y The monitoring of the accupack temperature during
charging in the L 2015 charger.
y The prevention of improper charging of inserted pri-
mary cells (batteries). Due to the missing sensor, indi-
vidual rechargeable battery cells will also not be
charged in the L 2015 charger.
Connecting units to the audio output
You can connect a PA system or a recording unit (e.g. video
camera) to the receiver.
̈
Connect one of the supplied line output cables to the
recording unit.
̈
Connect the 3.5 mm jack plug to the audio output (AF
OUT)
¹
.
̈
Lock the 3.5 mm jack plug by screwing down the
coupling ring.
̈
Via the operating menu, adapt the level of the audio
output (AF OUT) to the input sensitivity of the
connected unit (see “Adjusting the audio output level”
on page 23) .
Mounting the receiver to a camera
Use the supplied camera kit to mount the receiver to the
camera’s flash mount.
The camera kit consits of:
y 1 perforated plate ¹
y 1 flash mount adapter Ƹ
y 2 square nuts ƹ
̈
Determine where on the perforated plate the flash
mount adapter
Ƹ
will need to be fastened so that the
receiver can best be attached to the camera.
̈
At this position, place a square nut
ƹ
under the
perforated plate
¹
.
¹