Sony VPD-LE100 User Manual
Page 4
the device. The device shall be addressable for control over multiple devices
from a single remote control.
The wired / wireless backlit projector remote control shall operate in the same
fashion as the projector control panel, and shall accommodate infrared wireless
operation, or operation via a standard mini-plug cable. An infrared extender shall
be available from the device manufacturer for operation of the device wirelessly
in a rear-screen or cabinet environment.
The serial control jack shall employ the use of a standardized device control
protocol that is commonly accepted and understood by control systems
manufacturers. This control jack shall accept unidirectional serial commands that
provide full control over the device.
The advanced serial control jack shall employ the use of a standardized device
control protocol that is commonly accepted and understood by control systems
manufacturers. This control jack shall accept and transmit bi-directional serial
commands that provide full control over the device, and provide
acknowledgement to the control system of the received command.
The advanced serial control jack for control by external signal switchers shall
employ the use of a standardized device control protocol that is commonly
accepted and understood by control and signal switching manufacturers, and
shall operate at distances greater than 1000 feet without regeneration from an
external device. This control jack shall accept and transmit bi-directional serial
commands that provide full control over the device, and provide
acknowledgement to the control system of the received command.
The following device functions shall be available for control:
Power On / off
Input Selection
Brightness / Contrast
Video Decoder Functions
Audio Volume
Memory Recall Functions
White Balance
Gain / Bias Control
Image Sizing
Image Positioning
Lens Power Zoom
Lens Power Shift
Lens Power Focus