Schwinn 438 - Manual (Page 13)

11
A
S
S
E
M
B
LY
I
N
S
T
R
U
C
T
IO
N
S
ASSEMBL
Y INSTRUCTIONS
Parts
#17 Sub Pedal Arm Assy (Qty 2)
#20 Right Crank Cover (Qty 1)
#21 Left Crank Cover (Qty 1)
Hardware
#32 12.5x25x1.0T Arc Washer
(Qty 4)
#33 10.2x25x1.5T Flat Washer
(Qty 2)
#34 10x1.5 Nylon Hex Nut (Qty 2)
#41 4x16 Self-Tapping Round Head
Screw (Qty 2)
Step 6—Attach the Sub Pedal Arm Assemblies and Crank Covers
6–2 Install the Nylon Hex Nut (#34)
on the right Pivot Tube bolt.
6–3 Align the Wheel on the Sub
Pedal Arm Assembly (#17)
in the track on the Rear Rail
Assembly.
6–4 Place the Right Crank Cover
(#20) on the right Pivot Tube
(#22).
6–5 Secure the Right Crank Cover
(#20) with the Self-Tapping
Round Head Screw (#41).
6–6 Repeat steps 6–1 through 6–5
for the left Pivot Tube using the
Left Crank Cover (#21).
Figure A–6
32
34
33
32
17
34
22
33
32
20
41
17
17
41
Track
21
22
6–1 Place the Sub Pedal Arm
Assembly (#17), two (2) Arc
Washers (#32), and one (1) Flat
Washer (#33) on the right Pivot
Tube (#22), as shown in the
fi gure close-up below.