Storing your sunbeam multiprocessor – Sunbeam LC6200 User Manual

Page 18

The Sunbeam MultiProcessor was designed

so that all attachments can be stored
within the unit itself, see Figure 22.

Blade storage compartment
1. Your MultiProcessor is accessorised with 6

blades. Each of these blades are illustrated
and numbered above the blade storage
compartment, see Figure 23.

2. Pull down the blade storage door,

see Figure 24.

3. Each of the blades is numbered 1 through

6 and corresponds with the numbered
illustrations on the unit, see Figure 25.
Blade 1 is the ‘Thin Slicing’ blade and it’s
position in the blade storage compartment
is the far left front position, see Figure 26.

4. Blade 2 is the ‘Thick Slicing’ blade and is

positioned directly behind the thin slicing
blade.

5. Blade 3 is the ‘Chipping’ blade and it’s

position in the blade storage compartment
is the middle front position, see Figure 27.

6. Blade 4 is the ‘Grating’ blade and is

positioned directly behind the chipping
blade.

blade
storage
door

LC6200

Pictured

Storing your Sunbeam
MultiProcessor

Fig 25

Fig 22

Fig 23

Fig 24

Fig 26

Fig 27