Sunbeam LC6200 - Manual (Page 14)

12
Heading
Note: All attachments must be firmly
attached to the spindle. Always adjust the
attachments until you are sure that they are
correctly fitted.
Placing the spindle
1. Fit the spindle onto the drive shaft, see
Figure 6.
Processing Blade
1. Fit the processor bowl and spindle as
detailed previously in Figures 2, 3 & 6.
2. Remove the protective cover from the
stainless steel processing blade, see
Figure 7.
3. Fit the processing blade over the spindle
and press firmly into place, see Figure 8.
Warning: Use extreme caution, as blades are
sharp. Always handle the chopping blade by
it’s central plastic section.
4. Place food into the processing bowl.
5. Fit the processing cover to the processing
bowl, see Figures 4 & 5 and place the food
pusher in the feed tube.
6. Plug the power cord into a 230-240V AC
power outlet and turn the power ‘ON’.
7. Select the required speed.
8. When processing is complete, remove the
spindle and blade from the processing bowl
before removing the processed food.
Note: After cleaning, always replace the
protective cover on the stainless steel
processing blade.
Dough Blade
1. Fit the processor bowl and spindle as
detailed previously, in Figures 2, 3 & 6.
2. Fit the dough blade over the spindle and
press firmly into place, see Figure 9.
3. Place ingredients into the processing bowl.
4. Fit the processing cover to the processing
bowl, see Figures 4 & 5 and place the food
pusher in the feed tube.
5. Plug the power cord into a 230-240V AC
power outlet and turn the power ‘ON’.
6. Select required speed.
7. When processing is complete, remove the
spindle and blade from the processing bowl
before removing the dough.
Fitting/using the tools on your
MultiProcessor
spindle
chopping
blade
LC6200
Pictured
Fig 8
spindle
dough
blade
Fig 9
LC6200
Pictured
spindle
drive
shaft
LC6200
Pictured
Fig 6
Fig 7