Sunbeam LC6200 - Manual (Page 15)

13
Heading
Note: For added safety we recommend that
you always leave the food pusher in place
whilst operating the processor.
Whisk Attachment
1. Fit the processor bowl and spindle as
detailed previously in Figures 2, 3 & 6.
2. Fit the whisk attachment over the spindle
and press firmly into place, see Figure 10.
3. Add ingredients into the processing bowl.
4. Fit the processing cover to the processing
bowl in Figures 4 & 5 and place the food
pusher in the feed tube.
5. Plug the power cord into a 230-240V AC
power outlet and turn the power ‘ON’.
6. Select the required speed.
7. When processing is complete, remove the
spindle and whisk from the processing
bowl before removing the processed food.
Slicing, Chipping, Grating and Shredding Blades
1. Place the blade of your choice into the blade
holding disc. Hold the blade by the holding
clip and insert the other end into the blade
holding disc. Press down on the end of the
blade with the holding clip until the blade
is sitting flat in the blade holding disc, see
Figures 11 & 12.
2. Fit the processor bowl and spindle as
detailed previously, in Figures 2, 3 & 6.
3. Fit the blade holding disc over the spindle
and press firmly into place, see Figure 13.
Warning: Use extreme caution as the blades
are sharp.
4. Fit the processing cover to the processing
bowl in Figures 4 & 5 and place the food
pusher in the feed tube.
Fitting/using the tools on your MultiProcessor continued
Fig 11
Fig 12
blade
holding
disc
spindle
LC6200
Pictured
Fig 13
whisk
spindle
Fig 10