Sherwood Enviro EG40 DV - Manual (Page 9)

9
Figure 8: Blower (Fan) Removal.
1. Turn the unit off, allow it to cool down completely, and
remove the door as shown in the M
AINTENANCE AND
S
ERVICE
- O
PENING
T
HE
D
OOR
..
2. Remove the log set and brick liner.
3. Remove the burner tray assembly, see M
AINTENANCE AND
S
ERVICE
- B
URNER
R
EMOVAL
.
4. Remove the four (4) 5 /
16
” bolts that hold the blower
mounting plate to the back firewall. Use a light lubricating
oil on screws before removal.
5. Carefully pull the blower assembly into the firebox (see
Figure 7) disconnect the blower leads from the harness and
remove blower.
6. To re-install, check mounting plate gasket if damaged
replace with new one and reverse steps 1 through 4. Refer
to “S
ECONDARY
I
NSTALLATION
- L
OG
S
ET AND
E
MBERS
I
NSTALLATION
”.
Maintenance and Service
3. Vacuum the bottom of the firebox thoroughly. Carefully clean off any dust on the logs and remove any
lint from the main burner and pilot burner.
4. After carefully replacing the log and embers in their correct positions (see Secondary Installation -
Installation of Log Set and Embers), and the door has been resealed, re-light the pilot, following the
instructions on the lighting label attached to the unit.
C
LEANING
P
LATED
S
URFACES
:
It is important to note that fingerprints and other marks can leave a permanent stain on plated finishes.
To avoid this, give the face a quick wipe with denatured alcohol on a soft cloth BEFORE lighting the
fireplace. Never clean the face when it is not cool. Do not use other cleaners as they may leave a
residue, which can become permanently etched into the surface.
B
URNER
R
EMOVAL
:
The burner may need to be removed for a few reasons, including cleaning under the burner, converting
the unit to a different gas type, or to replace the burner altogether. Proceed only when the unit has
completely cooled down.
1. Remove the door as shown in the M
AINTENANCE AND
S
ERVICE
- O
PENING
T
HE
D
OOR
.
2. Remove the two (2) T-20 screws that hold
the burner in place; one (1) at each of the
rear burner (see Figure 7).
3. Lift the burner assembly (both the front and
rear burners) straight up then out.
To re-install the burner follow steps 1-3 in
reverse. When placing the burner back in the
unit ensure that the venturi box under the
burner is lined up.
R
EPLACING
T
HE
B
LOWER
:
Figure 7: Screws holding Burner.