Splendide WD2100XC - Manual (Page 13)

About your appliance 13
DOOR LOCK
LED
ON/OFF
OPTION
Buttons
DRY TIME
Selector
CYCLE
Selector
STATUS LED’s
WASH TEMP
Selector
START
ON/OFF (Door Open) Button
Turns power to the washer ON or OFF, unlocks the
door during the wash and dry cycles. Also restarts a
SILK or WOOL cycle that’s gone into Anticrease/
Soak.
DOOR LOCK LED
Indicates when the door is locked and when it can
be safely opened:
SOLID=Locked, FLASHING=Unlocked
Once locked, the door can be unlocked for up
to 5 MINUTES into any WASH cycle and at ANY
TIME during a DRY cycle.
To unlock the door: Press the ON/OFF button.
To resume the cycle: Close the door and press the
ON/OFF button again.
START (Cancel) Button
Press once to START the program, or press and hold
to CANCEL a program in progress.
OPTION Buttons
Use these buttons to modify the wash cycle (see
“Description of Option Buttons, page 12”) .
STATUS LED’S
Indicates the cycle phase that’s underway.
DRY TIME Selector
Use this knob to select the desired drying minutes.
MAX LOAD will dry for 180 minutes and is
recommended for full, 11 pound loads. NOTE: This
knob does not move during the dry cycle.
WASH TEMP Selector
Use this knob to select the water tempurature
(when a WASH cycle is selected. NOTE: Rinse water
is always COLD.
CYCLE Selector
Use this knob to select a WASH or DRY cycle.
NOTE: This knob does not move during the wash or
dry cycle.
Description of the control panel
IMPORTANT: The rapid flashing of the
DOOR LOCK LED together with flashing of
atleast one other LED indicates an
abnormality (see Troubleshooting)