Sunwave Tech. SRC-3000b - Manual (Page 40)

36
Appendix C Troubleshooting
Troubleshooting Tables
Problem Solution
LCD does not show
anything when you
touch it.
1. Batteries may be dead. Replace
the batteries with three new AAA
alkaline batteries (page 4)
2. Check that the batteries are
properly installed.
The SRC-3000b
doesn’t operate a
device.
1. Make sure that the desired device
key on the SRC-3000b LCD panel
has been selected.
2. Move closer to the device. The
maximum operating distance is
approximately 30 feet.
3. Ensure that you are aiming the
SRC-3000b directly at the device
and that there are no obstructions
between the SRC-3000b and the
device.
4. Ensure programming with the
learning function (page 15) or the
manufacturer codes has been
properly done.
5. Learn code the key (page 10).
You see “ERROR”
displayed during
operation.
1. The key that you pressed has not
been taught.
2. Teach the key using the learning
procedure (page 15).