Skyworth SLC-1963A-1 - Manual (Page 6)

INSTALLATION
Installation
Television Location
Follow these recommendations before deciding the
location of your television.
Avoid excessive sunlight or bright lights,
including reflections.
Keep away from excessive heat or moisture.
Inadequate ventilation may cause internal
component failure.
Fluorescent lighting may reduce remote
control transmitting range.
Keep away from magnetic equipment,
including motors, fans and external speakers.
WARNING: Use this television receiver only with the
cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart
is used, use caution when moving the Cart / apparatus
combination to avoid injury from tip-over. In order to
avoid injury to children, never place your television
receiver on a piece of furniture that is capable of being
tilted by a child leaning on it, pulling on it, standing o it,
or climbing on it. A falling television can cause serious
injury or even death.
Remote Control Battery Installation
Requires two AAA batteries(supplied).
Procedure
1. Turn the remote control face down. Remove battery
cover by pressing down on the marking on the
cover and sliding it off in the direction indicated.
2. Install batteries matching(+) and(-) polarity signs.
3. Replace the battery cover by sliding in reverse until
the lock snaps.
Note: Incorrect installation can cause battery leakage
and corrosion that will damage the Remote
control.
Precautions
Replace batteries in pair.
Do not mix battery types(zinc carbon with
alkaline).
Do not recharge, heat, short-circuit,
disassemble, or burn batteries.
POWER SOURCE
TO USE AC POWER SOURCE
Use the AC /DV adaptor provided for operation on AC.
Insert the AC cord plug into a standard 110-120V 60HZ
polarized AC outlet.
AC outlet
Wider Hole
and Blade
Polarized AC Cord Plug (One
blade is wider than the other)
5
To use Car cord
Use the Car Cord provided for operation on 12V DC.
NOTE:
1.AC/ DC adaptor provided can be connected to
the specified voltage (AC 110 volts 60HZ).
2.If the polarized AC cord does not fit into a non-
polarized AC outlet, do not attempt to file or cut
the blade. It is the user s responsibility to have
an electrician replace the obsolete outlet.
3.If you cause a static discharge when touching
the unit, and the unit fails to function, simply
unplug the unit from the AC outlet, wait a few
minutes, and plug it back in. The unit should
return to normal operation.
,