Siemens SL34A - Manual (Page 31)

E n g l i s h
30
(Interrupting and Cancelling Cycles,
Continued)
Interrupting a Cycle
Top Control
WARNING: YOU COULD BE
SERIOUSLY SCALDED IF YOU OPEN
THE DISHWASHER DOOR QUICKLY
DURING A WASH OR RINSE CYCLE.
ALWAYS WAIT AT LEAST 10 SECONDS
(OR UNTIL WATER NOISES STOP)
BEFORE FULLY OPENING THE DISH-
WASHER DOOR.
1. Open the dishwasher door far enough to
expose the control buttons.
2. To resume the cycle, simply close the
dishwasher door.
Cancelling and Changing a Cycle
Front Control
1. Press and hold for three seconds the
two buttons indicated by the two dots
labelled “Cancel Drain”, as shown in Figure
24.
2. You may now begin a new cycle by
following the instructions in the “Operate the
Controls” section of this manual.
Top Control
WARNING: YOU COULD BE
SERIOUSLY SCALDED IF YOU OPEN
THE DISHWASHER DOOR QUICKLY
DURING A WASH OR RINSE CYCLE.
ALWAYS WAIT AT LEAST 10 SECONDS
(OR UNTIL WATER NOISES STOP)
BEFORE FULLY OPENING THE DISH-
WASHER DOOR.
1. Open the dishwasher door far enough to
expose the control buttons.
2. Press and hold for three seconds the
two buttons indicated by the two dots
labelled “Cancel Drain”.
3. Close the dishwasher door.
4. You may now begin a new cycle by
following the instructions in the “Operate the
Controls” section of this manual.
Figure 24/Ilus. 24
Operation | Fonctionnement | Operación
Power
Scrub
Plus
Delicate/
Econo
Regular
Wash
Rinse &
Hold
88
Cycle
Countdown
Cancel
Drain