Samsung SilverCare WF306BAW - Manual (Page 9)

SAMSUNG Clothes Washer Owner’s Instructions A-5
3. Turn on “HOT” and “COLD “water supply and check all connections at
the water valve and the faucet for leaks.
4. Plug power cord into a 3-Prong, well grounded 120 volt 60 Hz
approved electrical outlet protected by a 15-amp fuse or comparable
circuit breaker.
Your Washer is grounded through the third prong of the power cord
when plugged into a three-prong grounded receptacle.
5. Slide your Washer into position.
6. Level your Washer by turning the leveling legs in or out as necessary
by hand.
When your Washer is level, tighten the nuts using the wrench
included with your Washer.
NOTE: Your Washer must be leveled on all four sides. A carpenter’s
level should be used on all four corners of your Washer. It’s
a good idea after the first dozen washes to recheck your
Washer’s levelness.
7. If you install your washer on softfloor, you should place the rubber
cup under adjustable leg. Before put rubber cup, please remove film
for double-side tape attached on rubber cup.
NOTE: If washer is installed on riser, you should put rubber cup
under leg for riser.
Installing Your Washer