Shindaiwa 89307 - Manual (Page 6)

Remove air cleaner cover
Lock Nut
Cable
Adjuster
Adjust as required for 4-6 mm free play
4-6 mm (3/16”-
1/4”)Throttle Free
Play
Throttle Lever Free Play
Gearcase
Flex drive
Shaft tube
Gearcase
clamp bolt
Gearcase
index bolt
6
Assembly
Prior to assembly
Before assembling, make sure you have all
the components required for a complete unit.
Carefully inspect all components for damage.
Outer Tube/Main Shaft Assembly
Ŷ
Cutting Attachment Shield
Ŷ
Edger Blade
Ŷ
Kit containing cutting attachment shield,
Ŷ
mounting bracket and hardware, this
owner's/operator's manual, and a tool
kit for routine maintenance.
Mounting the cutting attachment shield and edger blade
NOTE:
,WPD\EHQHFHVVDU\WRSXOOWKHÀH[FDEOH
out from the shaft tube, engage into the
gearcase and then slide the assembly
onto the shaft tube.
Loosen gearcase clamp bolt. 1.
Remove the gearcase index bolt. 2.
Slide the gearcase oriented as shown 3.
onto the shaft tube insuring that the
flex drive is engaged in the gearcase.
Reinstall the index bolt and tighten 4.
securely.
Tighten the clamp bolt and torque to 5.
52 – 69 inch-pounds.
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front” and
“rear” refer to directions as viewed by the
operator during normal operation.
Adjust Throttle Lever Free Play
The throttle lever free play should be
approximately 4 - 6 mm (3/16” - 1/4”).
Make sure that the throttle lever operates
smoothly without binding. If it becomes
necessary to adjust the lever free play, fol-
low the procedures and illustrations that
follow.
Loosen the air cleaner cover knob and 1.
remove the air cleaner cover.
Loosen the lock nut on the cable 2.
adjuster.
Turn the cable adjuster in or out as 3.
required to obtain proper free play
4-6 mm.
Tighten the locknut. 4.
Reinstall the air cleaner cover. 5.