Sharp XL-UH242 - Manual (Page 11)

XL-UH242_11-19.fm
11
XL-UH242
Preparation for Use
Antenna connection
Supplied FM antenna:
Connect the FM antenna wire to the FM 75 OHMS jack and position
the FM antenna wire in the direction where the strongest signal can
be received.
Supplied AM loop antenna:
Connect the AM loop antenna to the AM and GND terminals. Position
the AM loop antenna for optimum reception. Place the AM loop
antenna on a shelf, etc., or attach it to a stand or a wall with screws
(not supplied).
Note:
Placing the antenna on the unit or near the AC power cord may
cause noise pickup. Place the antenna away from the unit for better
reception.
Installing the AM loop antenna:
Speaker connection
Connect the black wire to the minus (-) terminal, and the red wire to
the plus (+) terminal.
Caution:
Speaker grilles are removable
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)
RATED SPEAKER IMPEDANCE: 6 OHMS MIN.
AC INPUT RIGHT
RIGHT LEFT VIDEO/AUX IN
SPEAKERS
LEFT
LEFT
RIGHT
SPEAKERS L IG H T -U P
ANTENNA FM
75 OHMS
AM GND
SUBWOOFER PRE-OUT
ANTENNA
FM
75 OHMS
AM GND
Use speakers with an impedance of 6 ohms or more, as lower
impedance speakers can damage the unit.
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
Do not stand or sit on the speakers. You may
be injured.
Make sure nothing comes into contact
with the speaker diaphragm when you
remove the speaker grilles.
RATED SPEAKER IMPEDANCE: 6 OHMS MIN.
AC INPUT RIGHT
RIGHT LEFT VIDEO/AUX IN
SPEAKERS
LEFT
LEFT RIGHT SPEAKERS L IG H T -U P
ANTENNA FM
75 OHMS
AM GND
SUBWOOFER PRE-OUT
RATED SPEAKER IMPEDANCE:
6 OHMS MIN.
RIGHT
SPEAKERS
LEFT
Black Red
RATED SPEAKER IM
PEDANCE:
6 OHMS M IN.
RIGHT
SPEAKERS
LEFT
Incorrect