Sharp CP-G20000S - Manual (Page 32)

32
06/2/14
Radio
CD-G20000_E3.fm TINSEA128AWZZ
CP-G20000S
CD-G20000 Listening to the radio (continued)
Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorized stations for a few hours
should there be a power failure or the AC power cord become
disconnected.
To recall a memorized station
To scan the preset stations
The stations saved in memory can be scanned automatically.
(Preset memory scan)
To erase entire preset memory
1 Perform steps 1 - 3 in "Tuning" on page 31.
2 Press the MEMORY button to enter the preset tuning sav-
ing mode.
3 Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY button to store that
station in memory.
If the "MEMORY" and preset number indicators disappear. be-
fore the station is memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorized for that preset channel number will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired
station is located.
1 Press the ON/STAND-BY button to enter the power standby
mode.
2 While pressing down the button and the button, press
the TUNER(BAND) button until "TUNER CL" appears.